Agrivoltaic Solar Mounting System

The Metal Roof Solar brackets is suitable for roofing with corrugated sheet metal, trapezoidal metal sheet. Hanger Bolt Kit is available for foot option, making the installation more convenience, competitive and reliable. The systems are fully comply with the Australian and other international standards on wind & snow load, making it suitable for a wide variety of climatic zones.

Dual-use in land for both agriculture and energy production can improve land use efficiency and increase crop production by over 30%. And it can provide an additional source of income for farmers, making it a financially attractive option.

Ground screw pile is a new type of pile foundation material, which has incomparable superiority advantage compared with traditional ground pile. The patented design is screwed into the ground to replace the concrete independent foundation and strip foundation. The top of ground screw pile is connected with the load.  The construction is not restricted by geological condition, construction efficiency, does not damage the environment, and it has more advantages of environmental protection. It can still be constructed even under severe cold weather conditions, It can facilitate migration and recycling. solar ground screw pile is not only a single product, but also includes a complete set of implementation solutions such as construction qualification, rich construction experience and management of technicians to ensure maximum service life.

Solar tracking system is oriented north-south and tracks east-west. Powered by motors and guided by astronomical algorithms, it aligns the module with the sun's azimuth. This optimizes direct sunlight exposure on the PV module surface to enhance power generation.

The Metal Roof Solar brackets are suitable for roofing with corrugated sheet metal, or trapezoidal metal sheet. A Hanger bolt is available for the foot option, making the installation more convenient, competitive, and reliable. The systems fully comply with the Australian and other international standards on wind & snow load, making it suitable for a wide variety of climatic zones.

Floating mounting system is applied to solar PV power plant installation on water. Adopting HDPE material, it has passed the Hunt Water Absorption Test, Anti-Aging Test, Anti-UV Test, etc. Moreover, it can bear the pulling force that is much higher than other products. Adopting new module design in floater and main floater, it enables the array of double row in the same facing or in symmetrical facing and increases the efficiency of solar power generation and installation capacity. Moreover, it can be easily installed and saves the cost.

Ballast PV System are applied to various kinds of flat roof projects. Main components made of hot-dip galvanized steel have good performance of structure strength, stability and anti-corrosion, and are compatible with varied solar modules. Patented structure design guarantees shorter installation time to save construction cost.

Triangular mounting brackets can easily apply to different flat roofs or open terrains since it has variable tilt angle and footing options for both roof clamp and roof penetration. Elevation can be used as fixed tilt or adjustable tilt, allowing project-specific adjustments and optimizing solar power output. The innovative high pre-assembly design eliminates on-site cutting and welding and enables quick and easy PV module installation.